Standover height explained
You straddle a bike and the top tube is right against you. Or you can't tell from a chart whether you'll clear it. Standover is the number that answers that.
What it is
Standover height is the height of the top tube above the ground.1 The top tube is the bar that runs from below the handlebars back to below the saddle.
Makers list it so you can compare it with your own leg length, the inseam, before you buy.
How much clearance is enough
Sheldon Brown describes the old rule. You'd stand over the frame, and if there was an inch or two between the top of the top tube and your body, that was the right size.2
Bicycle Guider gives a similar figure: 1–2″ of clearance between your crotch and the top tube, for comfort and safety.3
The same guide says a bike is too big if you can't stand over the frame with both feet flat on the ground without the top tube touching you.3
Why two bikes of one size can differ
Here's the symptom: two frames carry the same size label, yet one is much harder to stand over. There are a few causes.
- Bottom bracket height. Sheldon Brown notes that even frames using the same system for the top of the seat tube may have widely disparate stand-over heights. The bottom bracket is where the cranks attach. Its height varies over a considerable range, and a higher one lifts the whole frame.2
- Top tube shape. A top tube can slope down toward the seat tube to give extra standover clearance.1
Step-through frames
A step-through frame usually has a top tube that slopes down steeply, so the rider can get on and off more easily.1 Wikipedia adds that a top tube joined lower on the seat tube results in a lower standover height.1
Check the maker's own size guide to see which numbers it relies on for these frames. The geometry table page lists other rows to lean on.
A small-frame trap
Sheldon Brown says that when a small frame size has a higher bottom bracket than the other sizes of the same model, you're seeing dishonesty and deliberate deception.2
He adds that this problem is no longer as common, since the sloping top tube eliminates it.2 It's still a reason to read the actual standover figure on a smaller frame, and to be careful with older used bikes.
The lesson is simple. Compare the standover number itself, not the gap between size labels.
What standover doesn't tell you
It says nothing about how far you'll reach to the handlebars. A frame can pass the clearance check and still feel stretched or cramped. Reach and stack are covered separately.
It also doesn't set saddle height. That depends on the seatpost, covered on the saddle height page.
Notes and sources
- Bicycle frame, Wikipedia
- Revisionist Theory of Bicycle Sizing, Sheldon Brown
- Bike Size Guide to Choosing the Right Fit, Bicycle Guider